I have 40 heatshrink butt connectors and ring terminals, plus 10 heatshrink bare wire end caps for unused or loose wires.Some connectors are perma-seal brand.Connectors have never been used but were in my connector case for mobile installs. Here's what kit includes.20)- 18-22 gauge butt connectors10)- 14-16 gauge butt connectors 2)- 8 gauge butt connectors 6)- 14-16 gauge ring terminals 2)- 10-12 gauge ring terminals10)- 22-14 gauge wire end capsI have 3 packs of 50 for sale. I'll sell all 150 heatshrink connectors for $20
I have 50 Mil-Spec connectors and terminals for sale. These connectors are made of fine grade high conductivity copper, with special tin plating for corrosion resistance per ATSM-B-545. Connectors have never been used, and have been in storage bins.Here's a list of what lot includes.12)- Yellow 10-12ga butt connectors12)- Blue 14-16ga butt connectors12)- Red 18-22ga Butt connectors 4)- Yellow 10-12ga ring terminals 4)- Yellow 10-12ga female spade term 3)- Blue 14-16ga female spade terminals 3)- Red 18-22ga ring terminalsAll Connectors are.......UL 310 listed, CSA LR7189 and.... MEET OR EXCEED MIL-T-7928, Type II, Class 1 & 2 specifications.Any questions please ask, thanks.I have (3) 50 pc sets for ssle
I have 11 switch sensors of various uses ranging from triggering alarms, turning on interior lights, to automating actuators, etc. Switches can be placed under the hood, in the trunk, in a truck toolbox, ect.Switches are as follows: 2)- short pin switches 2)- long pin switches 2)- adjustable pin switches with brackets 2)- ball bearing tilt switches 2)- magnetic switches 1)- mercury tilt switchSwitches have not been used but have been bouncing around toolbox.
Uhaul class III hitch (4,000 lb), draw bar w/ 2" ball (hardware & instructions included). Fits 83-97 S-10 PU, 83-90 S-15 PU, 91-97 Sonoma. This hitch is still in good shape & ready to bolt on, no drilling required.
Used 1966 mustang rear bumper. could be easly recondition. shows signs of surface oxidation. if polished could look pretty good. straight. faint rust spot due to scuff. not visable from 5 ft. origanal part came off my car. priced to sell at 40.00. i replaced the one on my 66 with an aftermarket bumper.
Fifth Wheel Hitch - Pro Series 15000
Near new and has complete rail system with bolts.
Good for truck with 6.5 ft box or longer $300 OBO
Contact Fred at 352-233-3630
Vintage Lakewood "Traction-Action" traction bars for 1st & 2nd gen Camaro, Firebird, 68-79 Nova, Omega, Ventura. These bars can be outfitted with the "J" bolt kit (still available at Summit). Bars don't have the U-bolt kit that clamps them to the leaf spring (also still available). These bars can be cleaned & painted for your classic muscle car, or you can leave 'em as-is & put 'em on your Rat-Rod! You can call (352)-812-9947(leave message)
Serviced locally and regularly by Lee Marine352-840=5477 includeds New Bilage pump 3 new tires for trailer new gas tank andspare 5 galon tank new bimini top new outside cover magellal hand held gps new oar rod minnow bucket 4 life preservers all new gas lines new plugs and battery carberators rebuilt
2 - 185 x 80 R15 Nexen tires on 4 x15 Unilug Centerline wheels 2 - 275 x 60 R15 GoodYear tires on 8 x 15 Centerline wheels 5 lug - Ford or Dodge bolt pattern Like New $ 450.00 / OBO Call Mike 352-817-0683
This is the coil Spring suspension setup for a 2003 2004 2005 and 2006 Lincoln Navigator.
this suspension will replace your air suspension. this is for all four. front and rear. Fits 2wd & 4wd
Instructions included.
PHONE# 504-273-8714
front rear height sensor low air compressor solenoid