Parts for sale in Paw Paw, Michigan

1-4 of 4

Sort By

1974

1974

$15

Paw Paw, Michigan

Year -

Make -

Model -

Category -

Posted Over 1 Month

I was told this hood ornament was for a 1974, 1975, 1976 Cadillac Sedan DeVille and Fleetwood. It is in excellent like-new condition and does not appear to have ever been installed. It also comes complete with all of its parts including the retaining nut, flat washer, and rubber gasket. I'm asking $15.00 or best offer for it, and the shipping/handling charge would be $5.50, shipped anywhere in the U.S. If you have any questions or comments please feel free to drop me an e-mail. Thanks.

Kawasaki 500

Kawasaki 500

$30

Paw Paw, Michigan

Year -

Make -

Model -

Category -

Posted Over 1 Month

This is a factory Kawasaki service manual, issued 1971. It covers all phases of repair and maintenance of the 3 cylinder, 2 cycle 500 H1 and 350 S2 bikes. It contains many photographs, wiring schematics, a section on trouble shooting, and tech specs, in 125 pages. This book has a lot of finger smudges ,and a few stains, but is otherwise in very readable / usable condition. If you have any questions or comments, or you would like to make an offer, please free to e-mail me. Thanks

1948 Studebaker 1 ton truck trailer, or parts.

1948 Studebaker 1 ton truck trailer, or parts.

$800

Paw Paw, Michigan

Year -

Make -

Model -

Category -

Posted Over 1 Month

This is the back half of a 1948 Studebaker 1 ton pick-up that has been made into a trailer. It is amazingly solid for its age and general neglect. The only rust holes it has in it are two little holes (about the size of a green pea) in the floor of the box, and a sizable hole in each running board. Both running boards have been shortened but it might be possible to salvage some pieces from them. The frame was chopped in the front to form the tongue, and the last 6 or 8 inches of the frame tails were cut and bent to accommodate a rear bumper. The rest of the frame has no apparent damage or rust- through. The springs appear to be fully intact, and the axle still turns freely. I'm including extra wheels and tires. I'm asking $800.00 or best offer, and I would be happy to answer any questions or comments you might have.

Dodge magnum bucket seat and rear seat

Dodge magnum bucket seat and rear seat

$300

Paw Paw, Michigan

Year -

Make -

Model -

Category -

Posted Over 1 Month

A great pair of bucket seats and rear seat with little wear that fit a dodge magnum or will also fit charger and chrysler 300. These seats would also make a great pair for that project vehicle in the garage. Grey in color. Fabric material. Complete. Call 224-698-9368 Dave